JBL H (8Ohm). Unavailable. Category of diameter 12 inch / cm; Znom 8 ohm; Weight volume is not set, then delivery by plane is not possible. Brand New JBL H 12″ Aftermarket Recone Kit, 8 ohm. Parts specifications: Cone: 12″ outside diameter, ″ deep, ″ voice coil opening; Voice. Subwoofer JBL H. General specifications: diameter 12 inches, maximum power W. Thiele-Small parameters: frequency of self resonance Fs=75 Hz, .
|Country:||Papua New Guinea|
|Published (Last):||15 September 2014|
|PDF File Size:||11.19 Mb|
|ePub File Size:||13.1 Mb|
|Price:||Free* [*Free Regsitration Required]|
I was under the thought that the suffix was also something that showed intent or use of the driver eg- a single driver with a 16ohm impedance would be used for a total 3 or 4 way system impedance of 8 ohms, but a single 4 ohm driver would be used for a 2 way system impedance of 8 ohms Do what Tim recommended and give Charlie Tappa jb call.
Please update your browser to use Reverb
The letter suffix represents the impedance, not frequency range of the speaker. There was a ridge left behind from the old dustcap glue so I had to score the new cone near the former to get it to lay down flat, but once all the pre-fit was done, glue-ing it in wasnt too big of an issue rubber cement For a temporary fix I removed an older cone from another torched woofer, removed its suspension and dustcap, carefully removed the dustcap from the jbl and trimmed the glue from the cone as well as I could.
Do it as well as you possible can. In most cases-similar older JBLS can be reconed “kinda” as different model. February 19, Results 1 to 5 of 5. Thanks jbll everyone, good info all around. Like every job, it had it’s ups and downs. I do have a set of ‘s sitting around 2022g they are the midrange version.
Logged Brian Elstro Jr. Since the taper of the drivers was different I had to cut the new cone at an angle and push it to fit the taper. The is all its own and is even less a woofer, it’s dynamite about Hz and above. If we knew what the hell we were doing, we wouldn’t call it research would we. It sounds to me that you would prefer the ‘s over ‘s 2022b mid use. The kit is the same cost as a H.
All that being said, my original post was pre-emptive of checking the VC, which didnt seem to be effected at all. I’ve been thinking of replacing my bjl with ‘s down the road a bit and if ‘s can be reconed as ‘s then that could be an option It’s really a mid-range, a mid-bass at best. February 24, I don’t know anything about the The letter following the is used to designate the impedence.
Hi subwolf, thanks for the info.
JBL H 12″ Woofer Speaker Driver 8 Ohm | eBay
This message comes from JBL Dog. Blew a in the monitor older mr series due to a broken handle overexcursion None were specifically for “mid range”. Last edited by maxwedge; at Is it worth while to recone?
Logged “can you make them sing better? However the magnet structures and magnetic energy focusing are different-so you will end up some sort of “half breed”. Is it LF or MF and can it be reconed to a ? The differences in a 12″ driver in a 4 way system vs its 2-way sibling’s frequency response would be a huge factor, right? Dance to the radio. I guess you would call it JBL’s “midline” series driver. Basically the K, K, and shared the same magnet structure, including the top plate.
Read times Brian Elstro Jr.
JBL 2022H 12″ Aftermarket Recone Kit
It beat itself so badly that part of the cone was actually 2022 to the touch, and very weak. Ivan Beaver on February 19, Brian Elstro on February 18, You will get an enormous reward. You will have created something. I’m not aware of it ever being used in a 3-way app as a mid driver.
Sing in the shower. I have compared these side by side and could not find any jb in the basket. The time now is The rip went all the way around the dust cap which made me think that I had totally blown itand at one point into the middle of the cone. JBL, But it has been a few years.
JBL H 12″ Aftermarket Recone Kit – Speaker Exchange
The is also its own, it is an underhung design with a gap depth of 13mm. Another question, can the be reconed to the specs better LF handling? The x came in 3 versions listed below. Differences were achieved in cone composition, coil windings, and VC former material. All times are GMT Generally it will be more like the kit you put in it than the original-but will not have the exact same performance.