Consult International Marine’s INTERGARD brochure on NauticExpo. Page: 1/4. International Intergard is a high build, two component epoxy, pigmented with lamellar micaceous iron oxide for enhanced corrosion resistance and. Intergard is a two-pack epoxy coating, containing micaceous iron oxide, which can be overcoated after extended periods. Used as a.
|Published (Last):||21 November 2009|
|PDF File Size:||20.3 Mb|
|ePub File Size:||8.44 Mb|
|Price:||Free* [*Free Regsitration Required]|
Use International GTA only in exceptional circumstances. Open the catalog to page 3. A two pack epoxy coating, containing micaceous iron oxide, which can be overcoated after extended periods. Technical and application data herein is for the purpose of establishing a general guideline of the coating application procedures.
For example, an over integrard epoxy MIO may not have its interggard “textured” surface and will no longer be overcoatable after ageing unless it is abraded. For maximum performance ambient curing temperature should be Optimum performance is achieved when Intergard is applied intergafd blasted steel. Overcoating information is given for guidance only and is subject to regional variation depending upon local climate and environmental conditions.
The incorporation of plate-like micaceous iron oxide pigment both increases the barrier effect andimproves long term overcoating properties of the system, making this material ideally suitable forapplication in the fabrication shop, prior to shipping, with final overcoating at site. Low trade prices Our best trade prices on everything! When used as part of an approved scheme, this material has the following certification: Customer further agrees that we have no liability for any errors or omissions contained within the Product Data Sheets.
Frequency of cleaning will depend upon amount sprayed, temperature, relative humidity and elapsed time, including any delays. Chemical Resistant Coatings in Mumbai. Overcoating information is given for guidance only and is subject to regional variation depending upon local climate and environmental conditions.
Ideally suited as a damage and handling resistant coating which can be factory applied and interggard overcoated on site with minimum 40 preparation. Open the catalog to page 4.
This product is no longer in stock. VOC values are typical and are provided for guidance purposes only. Petersburg, Russia, phone: As application, environmental and design factors can vary significantly, due care should be exercised in the selection, verification of performance and use of the coating.
Always mix a complete unit in the proportions supplied.
Send us your question. Number of Employees Upto 10 People. The incorporation of plate-like micaceous iron oxide pigment both increases the barrier effect andimproves long Consult your local International Paint representative for intergatd recommendations. The figures stated above are approximate.
INTERGARD – International Marine – PDF Catalogs | Documentation | Boating Brochures
Optimum performance is achieved when Intergard is applied over blasted steel. Proper ventilation and protective measures must be provided during application and drying to keep solvent vapour concentrations within safe limits and to protect against toxic or oxygen deficient hazards. Typical Coverage per coat 5.
Get best deals for coconut. Clean all equipment immediately after use with International GTA Light Grey Part A Download.
Use in accordance with the standard Worldwide Marine Specifications. AkzoNobel IntergardPack Size: Take precautions to avoid skin and eye contact ie.
Call Send a quick message. Suitable for use in both new construction and industrial maintenance situations. Once units of paint have been mixed they should not be resealed and it is advised that after prolonged stoppages work recommences with freshly mixed units.
Use International GTA only in exceptional circumstances. These may be subject to variation depending on factors such as differences in color and normal manufacturing tolerances. Actual safety measures are dependant on application methods and work environment.
Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method.