A Ruger SP is likely in my future. I learned of a series of books called IBOK’s ( Iowegan’s Books of Knowledge). They used to be available for. Introduction. The Ruger SP is a great revolver, but the factory double action trigger pull can be heavy and a bit rough. It can be improved with a “trigger job”. In the library they have DIY tutorials for Ruger revolvers called the “Iowegian book of Knowledge” (IBOK). They’re pretty informational and have.
|Published (Last):||4 April 2009|
|PDF File Size:||11.2 Mb|
|ePub File Size:||18.67 Mb|
|Price:||Free* [*Free Regsitration Required]|
Does anyone have copies of these books they were apparently free to distribute they would be rugre to email me. When the hammer strikes the transfer bar and in turn the firing pin, much of the energy is dissipated by the top step on the hammer hitting the frame.
Often the factory leaves the back surface the flat area around the trigger guard latch hole longer than it should be. Look in the slot at the front of the crane. That’s true, but the book is apparently a really great resource on how the gun works, which was half of my interest. If the latch binds, you will have to locate the bind and dress the frame or crane latch. The spring loaded hammer dog part 65 fuger picked up by the trigger rugeg extension in DA.
IBOK for SP? : ruger
Grips are interchangeable between all models and are also the same as Ruger Super Redhawk grips. This is a bit tight for lead bullets. You can also make your own shims from a feeler gauge. Bluing only affects the surface of the metal so it will wear off, especially from using holsters.
Normally, GPs tend to carry-up a bit early.
ruge Wed Dec 05, 2: In this case, I authored and own the IBOK copyrights and as such, forum members were allowed to download a free copy for themselves but were not permitted by law to distribute them via email or post them elsewhere on the Internet. I’ll PM you and thanks in advance. Posted December 12, Do not try to drill any deeper, just get the hole smooth. Footer title This content can be configured within your theme rugfr in your ACP.
Pawl is pulled down to reset position. If you find the SP one, please let me know.
Posted December 16, The IBOKs were posted as an incentive for member recruitment and to encourage members to post questions, answers, comments, suggestions, photos, etc so there was a 10 post requirement before members could access the library. A corrupted forcing cone will affect accuracy and will increase bullet fouling.
Do the serial number side of the gun ibik then start the hammer pivot pin and do the other side.
The surfaces do not need to be perfectly flat and smooth. This is the surface that pulls the cylinder latch down. The GP has a larger frame, thicker cylinder, improved grip mounting system, trigger return spring, front sight, internal cylinder retainer, and trigger guard latch.
Pull the trigger guard latch spring part 44and the trigger link plunger part 47 out of the hole in the trigger guard part I haven’t test fired the gun ibom after doing the work.
Can it take moonclips without modification? This can be measured by laying gap gauge blades on the recoil shield and matching protrusion to thickness. You can accomplish a good cleaning without taking the internal cylinder parts out.
Ruger SP101 IBOK
Once the trigger is out, you can dress the high spots on the sides of the trigger or the inside of the struts. Now I understand what all the fuss is about.
This is a link contained in the above thread, but it is one to study closely if you want to go all the way into the Ruger. Apply a drop of oil to the trigger pivot pin and trigger plunger. I shot about 60 rds of HP’s thru GP in g and g bullets: