DPM 8016 PDF

Der DPM ist die modulare, vernetzbare Zentraleinheit des. PROMATRIX Systems. Über acht Steckplätze kann das Sys- tem durch Audio-Eingangs- . View and Download Dynacord DPM operation manual online. DPM Recording Equipment pdf manual download. View and Download Dynacord DPM owner’s manual online. PROMATRIX PAGING MANAGER. DPM Music Equipment pdf manual download.

The scope of delivery includes a 2-pole connector.

Pin assignment of Ethernet jack 3 on one side of the crossover cable. By pressing ‘print’ button you will print only current page. Flexible CU strand, LiY, 1. Interface Description The connections of the Ethernet interfaces can be seen in the following figure and table.

In- stead, of that the network configuration of the DPM should be done manually. Enter text from picture: Page 806 40 Go.

Dynacord DPM 8016 Owner’s Manual

Attachment on the front panel When installing in cabinet racks, installation rails should always be used to prevent the front panel distorting. Arrangements are made with the dealer where you purchased the equipment from, for the returning of all unusable equipment at no cost, to the factory in Straubing, for environmental dlm disposal.

LED indicator flashes during data transfer. Installation DPM Figure 5. Don’t show me this message again. Scope of delivery Warranty For information regarding the warranty, see www.

DYNACORD DPM 8016 digital matrix manager

The CM-1 module used here has two Ethernet connections to set ddpm a redundant network. Enter text from picture: A single DPM can manage up to 16 call stations and up to loudspeaker circuits; in larger systems, up to ten DPM controllers can be linked with each other via a digital audio and control bus.

By pressing ‘print’ button you will print only current page. DPM Technical data en Frontal Mounting Illustration The indicator is off, when the DPM has been separated from the power supply, the power supply has been switched off or in case of power outage.

If a crossover cable is used in 80166 to connect a DPM with a PC directly, pair 2 has to be interchanged with pair Illustration The lightning symbol inside a triangle notifies the user of high-voltage, uninsulated lines and contacts inside the devices that could result in fatal electrocution if touched.

Control Port Fehler im System vor.

WEEE, please contact your local distributor. Technical data DPM TA TB Tabelle vpm To print the manual completely, please, download it. Internet verbunden sind, von Interesse.

DPM PROMATRIX CONTROLLER System overview |

Please ensure that dom dripping water or spray can penetrate the inside of the device. Audio routing A digital 36 x 16 audio matrix is integrated into the DPM TB is more widely used.

To integrate the DPM into the hazard alert systems, a normally-closed contact standby current principle is recommended, i. Conductor cross-sections of 0. DPM is disconnected from the voltage supply or if the voltage supply is switched off or fails.

DYNACORD DPM OPERATION MANUAL Pdf Download.

A single DPM can manage up to 16 call stations and up to zones; in larger systems, up to 10 DPM controllers can be linked with each other via a digital audio and control bus. The lower half has six freely configurable control outputs and a ready contact, and slave clocks can also be connected. Page 5 DPM Safety notes en The PROMATRIX system also supports emergency power operation — in the event of a power failure, the DPM can assume all power management functions, that is, all unnecessary internal and external consumers switch to standby mode, or are deactivated and only reactivated again when required.

In an IP network, IP addresses are used for the logical address assignment of devices. To print the manual completely, please, download it. dpk

The following diagram shows a sample application with four DPM controllers in a connected Ethernet.