ASTM EStandard Test Method for Determining Volume 1 95 % Con? dence Interval Multipliers No. of Fields n 5 6 7 8 9 10 11 12 13 ASTM Standard E, using an image analysis routine with Leica .. of Constructional Steel Research 64(11) doi: / ASTM E Standard Test Method for Determining Volume Fraction by Systematic Manual Point Count. Front Cover. American Society for Testing and.
|Published (Last):||2 March 2014|
|PDF File Size:||6.28 Mb|
|ePub File Size:||5.48 Mb|
|Price:||Free* [*Free Regsitration Required]|
If another method of? E5662-11 values in Table 2 do not correspond to theoretical constraints; but, by using these values, empirical observations have shown that the method is optimized for a given precision.
No other aatm of measurement are included in this standard. Originally published as E — Thus, the method can be applied to any type of solid material from which adequate two-dimensional sections can be prepared and observed. This test method has been described 4 as being superior to other manual methods with regard to effort, bias, and simplicity. A superscript epsilon e indicates an editorial change since the last revision or reapproval.
This method is applicable only to bulk opaque planar sections viewed with re? Thus, the method can be applied to any type of solid material from which adequate twodimensional sections can be prepared and observed. Point counting measurements should be completed on different? In this case, more rigorous statistical signi? Improving the Volume Fraction Estimate Repeated point count measurements on an individual micrograph is not allowed.
A aztm average can be calculated by taking the average of the set means in this case.
ASTM E562 – 11
If no sample heterogeneity is indicated that is, the con? Diagrams of two possible grids, one with a circular pattern and one with a square pattern, which are recommended for use, are shown in Adtm. Work Item s – proposed revisions of this standard. The use of —point grid facilitates easy volume percent calculations. The point grid, with four times the number of grid points, decreased? Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
To avoid bias, questionable points should be counted as one half. Individual reprints single or multiple copies of this standard may be obtained by contacting ASTM at the above address or at phonefaxaastm service astm.
Standard Test Method f A number in parentheses indicates the year of last reapproval. NOTE 1— Table 1 gives the e56211 multiplying factors t for any number of?
ASTM International – Standard References for ASTM E – 11
Guidelines are given in 7. This standard is subject to revision at any time by the ee562-11 technical committee and must be reviewed every? Two common types of grids circular or square array are shown in Fig.
This can be achieved by using either a circular grid or a square grid placed at an angle to the microstructural periodicity. Summary of Test Method 4.
It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
The equations for calculating these values are as follows: The value of the multiplier, t, can be found in Table 1. This can be accomplished by moving the x and y stage mechanism a?