Source ACMC direct from stocking distributors and other suppliers. Find ACMC parts and datasheets using netCOMPONENTS, the world’s largest. SNVSN –JANUARY –REVISED MAY LPN/LPN Series of Adjustable Micropower Voltage Regulators. Check for Samples: LPN. » Datasheets» Поиск ACMC. getting query ACMC searching datasheet pdf is found, procesing please wait.
|Published (Last):||15 June 2006|
|PDF File Size:||10.5 Mb|
|ePub File Size:||10.90 Mb|
|Price:||Free* [*Free Regsitration Required]|
Where designed to be soldered at high temperatures, “RoHS” products are suitable for use in specified lead-free processes.
Use of TI Resources may require a license from a third amcc under the patents or other intellectual property of the third party, or a license from TI under the patents or other intellectual property of TI. Such equipment includes, without limitation, all medical devices identified by the U.
Input-output voltage ranges from 40 mV to mV, depending on load current. If timing, start-up, noise, PSRR, or any other transient specification is required, the design becomes more challenging. Alternatively, it may be programmed for any output voltage between its 1. Line Transient Response Figure Finish options are separated by a vertical ruled line.
Variable-frequency drive wikipedialookup.
Dropout Voltage Figure Low Drift Current Source 9. Output Impedance Figure If OUT is forced below 0 V before EN goes high and the load current required exceeds the fold back current limit, the device may not start up correctly. Ground or leave open if shutdown feature is not to be used.
ACS Price & Stock | DigiPart
Opto-isolator wikipedialookup. Input Current Figure 5.
Electrical ballast wikipedialookup. Successfully implementing an LDO in an application depends on the application requirements. Please consult factory for custom voltages. Line Regulation Figure When used in dual-supply systems where the output terminal sees loads returned to a negative supply, the output voltage should be diode-clamped to ground.
Efficiency is defined by the 291 of output voltage to input voltage because the LPN and LPN is a linear voltage regulator. The circuit outputs a high level while input current is less than 3.
This information is the most current data available for the designated devices. A second feature is the logic-compatible shutdown input which enables the regulator to be switched on and off. A ceramic output capacitor can be used if a ackc resistance 251 added recommended value of resistance about 0.
Результаты поиска для 2951ACMC
Continuously running the device into thermal shutdown degrades its reliability. Reproduction of significant portions of TI information in TI data sheets is permissible only if reproduction is without alteration and is accompanied by all associated warranties, conditions, limitations, and notices. Product device recommended for new designs.
If the requirements are simply input accmc and output voltage, compliance specifications such as internal power dissipation or stability must be verified to ensure a solid design.
TI bases its knowledge and belief on information provided by third parties, and camc no representation or warranty as to the accuracy of such information. Page numbers for previous revisions may differ from page numbers in acmd current version.
Also, the part may be pin-strapped for a 5-V, 3-V, or 3. Most types of tantalum or aluminum electrolytic work fine here; even film types work but are not recommended for reasons of cost. The minimum input-output voltage ranges from 40 mV to mV, depending on load current.
ACMC – РАДІОМАГ РКС КОМПОНЕНТИ
Designers are solely responsible for compliance with all legal and regulatory requirements in connection with such selection. During a current-limit event, the LDO sources constant current. At lower values of output current, less output capacitance is required for stability.
In order to meet different application requirements, LPN can also be accmc as a programmable voltage regulator, with an external resistors network; please refer to Application and Implementation for more details.
Short Circuit Current Figure The out of regulation condition may be due either to low input voltage, current limiting, or thermal limiting. When FB is connected to ground, the pass element is fully turned on and out voltage will be close to input voltage.
Consult product folder for more information on available options. Surge protector wikipedialookup. Any dimensions in parenthesis are for reference only.